HIGH FLASH HYDROCARBON SOLVENT

HOW TO REMOVE UNKNOWN STAINS

Below are the steps you will take to remove an unknown stain prior to cleaning in a high flash hydrocarbon solvent.

HIGH FLASH HYDROCARBON SOLVENT

HOW TO REMOVE UNKNOWN STAINS

Below are the steps you will take to remove an unknown stain prior to cleaning in a high flash hydrocarbon solvent.

Step 1

Apply Pyratex® LV then flush with water or steam. Then, apply WetDry® then flush with water or steam. Repeat if necessary.

Step 2

If stain is gone go to step 4. If stain remains, go to step 3.

Step 3

Apply StreeTAN®, then flush with water or steam. If stain is gone, go to step 4. If stain remains, apply StreePRO®, then flush with water or steam and continue to step 4.

Step 4

Level with Sofspot® or SPOTless® hc. When rinsing spotting agents in drycleaning with steam or water, it is important to control moisture aka “level” to prevent spotting rings and fabric damage. To level:

a. After fabric has been rinsed and air-dried, apply leveling agent liberally to the treated areas.

b. Lightly tamp the wet area, including the fabric areas just outside the ring.

c. Do not flush, rinse, or dry.

d.Continue with the drycleaning process.

Step 5

Dryclean as you normally would.

Please note that we recommend testing the stain removal agent on an unexposed seam prior to application on the stain if you are unsure of the nature of the stain.

PRODUCTS USED:

PYRATEX® LV

WETDRY®

STREETAN®

STREEPRO®

SOFSPOT®

SPOTLESS™ HC

Step 1

Apply Pyratex® LV then flush with water or steam. Then, apply WetDry® then flush with water or steam. Repeat if necessary.

Step 2

If stain is gone go to step 4. If stain remains, go to step 3.

Step 3

Apply StreeTAN®, then flush with water or steam. If stain is gone, go to step 4. If stain remains, apply StreePRO®, then flush with water or steam and continue to step 4.

Step 4

Level with Sofspot® or SPOTless® hc. When rinsing spotting agents in drycleaning with steam or water, it is important to control moisture aka “level” to prevent spotting rings and fabric damage. To level:

a. After fabric has been rinsed and air-dried, apply leveling agent liberally to the treated areas.

b. Lightly tamp the wet area, including the fabric areas just outside the ring.

c. Do not flush, rinse, or dry.

d.Continue with the drycleaning process.

Step 5

Dryclean as you normally would.

Please note that we recommend testing the stain removal agent on an unexposed seam prior to application on the stain if you are unsure of the nature of the stain.

PRODUCTS USED:

PYRATEX® LV

WETDRY®

STREETAN®

STREEPRO®

SOFSPOT®

SPOTLESS™ HC